1 - 10 of
27,076 results for
Configuring Cisco Discovery Protocol on Cisco Routers and Switches Running Cisco IOS
This document explains how to configure Cisco Discovery Protocol (CDP) on Cisco routers and switches that run Cisco IOS®. Specifically, the document covers how to enable, verify, and disable CDP on Cisco devices...
21 Nov 2006
This document is intended to help determine why a port or interface experiences problems. This document applies to Catalyst switches that run CatOS Software on the Supervisor or Cisco IOS® System Software on the Supervisor.
03 Apr 2009
This document describes how to configure a management IP address on Catalyst 4500/4000, 5500/5000, and 6500/6000 series switches that run Catalyst OS (CatOS) and Cisco IOS® Software. This document also includes Catalyst fixed configuration switches, which...
15 Mar 2006
...access list. Router(config)# access-list...deny | permit} protocol source source-wildcard... Purpose Router(config-if...destination. To configure the system to... NHRP can run on Cisco Express Forwarding...platforms when NHRP runs with BGP over...NHRP to initiate switched virtual circuits... Prior to Cisco IOS Release 12.0...
23 May 2005
This document explains the step-by-step procedure to upgrade the software image on Catalyst 6000/6500 series switches that run Catalyst Operating System (CatOS) on Supervisor, Cisco IOS on MSM/MSFC and Cisco IOS System Software. The software...
27 Aug 2009
This document provides best practices for Catalyst 6500/6000 and 4500/4000 series switches that run Cisco IOS® Software on the Supervisor Engine.
03 Sep 2006
...x 13 Configure Configuration...TechNotes) Configuring Cisco Discovery Protocol on Cisco Routers and Switches Running Cisco IOS Troubleshoot...
09 Oct 2010
...Node When you configure LLDP or CDP location information on a per-port basis...devices can send Cisco medianet location information to the switch. For more information...refer to the Using Cisco Discovery Protocol module. CDP...only one wired switch to report the...devices such as routers and switches...
15 Feb 2011
...standard protocol for hosts...SSM to rely on IGMPv3...last hop routers and host...applications running on those...applications, two Cisco-developed...see the "Configuring Source Specific...by Cisco IOS software...IGMPv3 with switches that support...originating on or destined to the router will be process...documents: •Cisco IOS Switching... •Cisco IOS Switching Services...encapsulation must be configured. •RTP...networks, Cisco routers would...and E were running the Open...OSPF) protocol. Router...
01 May 2003
This document is an informal discussion of some Cisco configuration settings that network administrators should consider changing on their routers, especially on their border routers, in order to improve security. This document is about basic boilerplate configuration...
07 Jun 2011