|
|
|
|
|
1 - 10 of
76 results for
NTM Out of Frames Red Error
|
|
|
|
...will not accept any Fibre Channel frames. In MNM, the adapter transmits a fixed 288-byte Ethernet frame that contains debug information...also know the version number of the adapter . There are two versions...information and eventually runs out of memory. Figure 5 Finding...follows: •No truncate mode (NTM) •Ethernet truncate mode...
www.cisco.com/en/US/docs/storage/san_switches/mds9000/hw/paa/installation/note/FPAA2.html
29 Jun 2007
...burnfwrev before the completion of resetcd, makes the UXM card to...Closed CSCdw47805 Possible NTM SR trunk with mismatch tx ts queue...Unreproducible CSCdx34134 testdelay times out every now and then: Closed ...Time zone not specified in event, error or abort logs: Closed CSCdx48623...loop back added to a trunk on a Y-RED UXM: Unreproducible CSCdx68364...addcon returns Other end QIR out of range for this end card: Duplicate...
www.cisco.com/en/US/docs/switches/wan/bpx/release/notes/9351rn.html
14 Apr 2008
...Symptom: When inserting 1E-03 errors into the whole frame of STM-4 trunk 3.1 (errors inserted in the direction A to...VT to A from another BPX times out and there’s an HPOV event stating...
www.cisco.com/en/US/docs/switches/wan/bpx/release/notes/9351rn.pdf
1935KB
...bytes CRC FC frame Ethernet frame Ethernet payload 85765 Se...transmits a fixed 288-byte Ethernet frame that contains debug information...support, also know the version number of the adapter . There are two versions...information and eventually runs out of memory. Figure 5 Finding...follows: • No truncate mode (NTM) • Ethernet truncate mode...
www.cisco.com/en/US/docs/storage/san_switches/mds9000/hw/paa/installation/note/FPAA2.pdf
746KB
...Clearing etc. CSCdp15671 Software error 105 CSCdp15712 Can not add con...causes trunk Mgr Ret Yel and LOF (RED) CSCdp20961 Swerr 5019 occured...CSCdp23410 UXM physical trunks with VPI of 0 does not work CSCdp24319 Dspcon...IMA trunk CSCdp25685 Software error 1012 logged upon a delshelf on...test CSCdp31596 IGX 9.2.22 NTM does not support FST in traffic...CSCdp04046 Increase cm update time-out from 30 seconds to 90 seconds CSCdp05661...
www.cisco.com/en/US/docs/switches/wan/bpx/release/notes/9238rn.html
14 Apr 2008
...This Command: cnftrkparm 3 NTM-T1 mulder TN StrataCom IGX 8420...TRK 4 Config T1/24 [8000 pps] NTM slot:4 Line DS-0 map: 0-23...No Link type: Terrestrial Line framing: D4 Line coding: B8ZS Line cable...4 Parameters: 1 Yel Alm-In/Out (D) [ 600/ 600] 18 Red Alm-In/Out (D) [ 2500...
www.cisco.com/en/US/docs/switches/wan/bpx/release/notes/9238rn.pdf
1565KB
...protocol (keep alive time-out count) – LMI sequence number error count – LMI receive status...response to request) – Transmit frames during LMI alarm – Transmit...Channel Counters – Number of frames received – Number...protocol (keep alive time-out count) • LMI sequence number error count • LMI receive status...response to request) • Transmit frames during LMI alarm • Transmit...Channel Counters • Number of frames received • Number...
www.cisco.com/en/US/docs/switches/wan/mgx/mgx_8850/software/mgx_r1.1.3/mgx_8250/overview/8250over.pdf
2174KB
...protocol (keep alive time-out count) – LMI sequence number error count – LMI receive status...response to request) – Transmit frames during LMI alarm – Transmit...Channel Counters – Number of frames received – Number...protocol (keep alive time-out count) • LMI sequence number error count • LMI receive status...response to request) • Transmit frames during LMI alarm • Transmit...Channel Counters • Number of frames received • Number...
www.cisco.com/en/US/docs/switches/wan/mgx/mgx_8850/software/mgx_r1.1.3/mgx_8230/overview/8230over.pdf
2111KB
...Indication Signal (AIS) • Detection of Out of Frame (OOF) condition Card Status... Active (Green), Failed (Red), Standby (Yellow) Line Status...Automatic generation of Far End Block Error (FEBE) FRSM-2T3E3 Specifications...
www.cisco.com/en/US/docs/switches/wan/mgx/mgx_8230/installation/guide/8230IC.pdf
2623KB
This document provides common IGX configuration scenarios that are typically found in real working networks. The majority of these labs are simple,yet effective,in demonstrating the abilities of the multiservice IGX switch.
www.cisco.com/en/US/products/hw/switches/ps988/products_configuration_example09186a00801c1211.shtml
30 Apr 2009
|
|
|
|
|
