|
|
|
1 - 10 of
2,353 results for
Replacing the Alarm Interface Panel on a Cisco ONS 15454
|
|
|
|
This document describes how to change the alarm interface panel (AIP) board on a Cisco ONS 15454 shelf.
www.cisco.com/en/US/products/hw/optical/ps2006/products_tech_note09186a0080094b06.shtml
23 May 2006
...and data traffic on a single platform. The ONS 15454 SDH allows users...Figure 1. Figure 1 Cisco ONS 15454 SDH ...assembly, a front panel with a liquid crystal...display (LCD), and alarm indicators. All...15454 SDH software interface, provides easy card...LEDs on the front panel of the AIC-I indicate the status of the alarm lines. Orderwire allows a craftsperson to plug a phoneset into an ONS 15454 SDH and communicate...orderwire channels on a SONET/SDH ring...regenerator is not a Cisco device. Orderwire...individual optical interface in the ONS 15454...
www.cisco.com/en/US/docs/optical/15000r4_0/15454/sdh/overview/guide/PO.html
01 Apr 2003
...describes how to install the alarm interface panel (AIP) standoffs to allow...Step 1 Loosen and remove the screws that attach the clear cover to the ONS 15454 backplane. Remove the clear...the backplane. Step 4 Replace the clear cover on the backplane, and insert...documentation, submitting a service request, and gathering...monthly What's New in Cisco Product Documentation...
www.cisco.com/en/US/docs/optical/spares/15454/sonet/guides/AIPstand.html
26 Oct 2009
The equipment failure Invalid MAC Address (INVMACADR) is a Major (MJ), Non-Service Affecting (NSA) alarm that occurs when the MAC address of a Cisco ONS 15454 is invalid. This document explains the causes of this problem and provides the...
www.cisco.com/en/US/products/hw/optical/ps2006/products_tech_note09186a00801d85d1.shtml
03 Feb 2005
...procedure describes how to replace a failed TPA fuse on the Cisco ONS 15454-FAP-4 fuse alarm panel. Note When a TPA...procedure describes how to replace a power bus module on the Cisco ONS 15454-FAP-4 fuse alarm panel. Note When replacing...
www.cisco.com/en/US/docs/optical/spares/15454/sonet_sdh/guides/fap4.html
25 Jul 2011
...panel. In addition, locate the appropriate FAIL (A1, B1, B2) terminals on the rear side of the fuse alarm panel. Use a multimeter (set to test continuity...for testing is removed and replaced with good fuses in all the...describes how to operate the Cisco ONS 15454-FAP-LVD2 fuse alarm panel...
www.cisco.com/en/US/docs/optical/spares/15454/sonet_sdh/guides/faplvd2.html
14 Jan 2010
...required to access TL1 using the craft interface. Caution Always use the supplied ESD wristband when working with a powered ONS 15454. For detailed instructions on how to wear the ESD wristband, refer to the Cisco ONS Electrostatic Discharge...Install an External Wire-Wrap Panel to the AEP" procedure...AEP to provide the physical alarm contacts for the AEP. ...
www.cisco.com/en/US/docs/optical/15000r9_1/15454/sonet/procedure/guide/454a91_insshelfbc.html
29 Aug 2012
...cards are not available, the MXP_2.5G_10G card...requirements. This will result in a clock alarm. The ALS procedure is supported on both client and trunk interfaces. On the client interface...10G card, refer to the Cisco ONS 15454 DWDM Procedure Guide. Table...during the boot process. Replace the card if the red FAIL...
www.cisco.com/en/US/docs/optical/15000r9_0/dwdm/reference/guide/454d90_txpmxpcard.html
03 Jul 2012
...under Products Affected. The Cisco ONS 15454 R6.0 software has been improperly populated to raise an MEA alarm against the BIC-B (EIA panel) when either a 1BNCB48, 1BNCB24, or 1SMBB84...version EIA panel is installed on an SA-HD version shelf assembly...assembly, this can result in interface ports to the system becoming...
www.cisco.com/en/US/ts/fn/620/fn62215.html
14 Feb 2006
...alarm persists, complete the Replace an Alarm Interface Panel procedure located in the Alarm Troubleshooting chapter of the Cisco ONS 15454 Troubleshooting Guide...adjacency is established on a point-to-point subnet...
References:
12
TAC
www.cisco.com/en/US/docs/optical/15000r9_2_1/dwdm/troubleshooting/guide/b_454d921_ts_chapter_011.html
28 Nov 2011
|
|
|
|
