|
|
Recommended Content
Support Toolbox
|
1 - 10 of
124 results for
Troubleshooting Input Errors on PA-A1 ATM Port Adapters
|
|
|
|
This document describes how ATM port adapters report traffic statistics and resolve issues with incorrect packet or byte counters displayed in the output of the show interface atm or show atm vc commands.
www.cisco.com/en/US/tech/tk39/tk48/technologies_tech_note09186a0080094ba1.shtml
18 Dec 2007
This document can help you to determine the reasons behind cyclic redundancy check (CRC) errors on your ATM interface.
References:
6
TAC
www.cisco.com/en/US/tech/tk39/tk48/technologies_tech_note09186a00800c93ef.shtml
15 Nov 2007
This document provides the information you need to understand and troubleshoot output drops on ATM interfaces.
www.cisco.com/en/US/tech/tk39/tk48/technologies_tech_note09186a00800c93dc.shtml
15 Nov 2007
This document discusses general and specific causes for slow performance on ATM networks and procedures to help troubleshoot the problem. The focus of this document is on troubleshooting IP performance issues, specifically on ATM networks. Typically,...
www.cisco.com/en/US/tech/tk39/tk371/technologies_tech_note09186a00802878e7.shtml
04 Aug 2004
...Processor Memory Requirements Port Adapter Type Product Number Bandwidth...Acceleration Module VPN Service Adapter (VSA) C7200 VSA Because...are required. 9 MB — ATM 1-port multimode PA-A1-OC3MM High 300 0...
References:
9
TAC
www.cisco.com/en/US/docs/routers/7200/configuration/7200_port_adapter_config_guidelines/3875In.html
16 Oct 2006
The ATM Forum publishes multi-vendor recommendations to further the use of ATM technology.
References:
5
TAC
www.cisco.com/en/US/tech/tk39/tk51/technologies_tech_note09186a0080102a42.shtml
05 Jun 2005
ATM is both a layer-2 protocol and a protocol stack, similar to the way in which IP is a layer-3 protocol and a protocol stack. The ATM Reference Model table illustrates the protocol stack for ATM.
www.cisco.com/en/US/tech/tk39/tk49/technologies_tech_note09186a00800d73b7.shtml
15 Nov 2007
...packets/sec 54033 packets input, 81670740 bytes, 0 no buffer...0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun...from the show version command on a Cisco 7200 series router...7200 Series Design Library: ATM Traffic Management OL-3274-01...s) 4 Channelized T1/PRI port(s) 125K bytes of non-volatile...requirements Cisco 7200 Series Port Adapter Hardware Configuration Guidelines Hardware installation • PA-A1 ATM Port Adapter Installation...
www.cisco.com/en/US/docs/routers/7200/design/ATM-traffic_management_guide/atmtrafc.pdf
2155KB
...section are not supported on the ATM port adapter (PA-A1 series). The ABR service...on the ATM port adapter (PA-A1 series). The 1-port ATM-25 network module only...configuring traffic parameters on an SVC, see the section...interface atm slot/port-adapter/0[.subinterface-number...config-if-atm-vc)# ubr output-pcr [input-pcr] or Router(config-if-atm-vc...
www.cisco.com/en/US/docs/ios/atm/configuration/guide/atm_15_0_book.pdf
13849KB
...not supported on the ATM port adapter (PA-A1 series). The 1-port ATM-25 network module only supports...configuring traffic parameters on an SVC, see the section...interface atm slot / port-adapter /0[. subinterface-number...config-if-atm-vc)# ubr output-pcr [input-pcr] • • • Router(config-if-atm-vc...
www.cisco.com/en/US/docs/ios-xml/ios/atm/configuration/12-4/atm-12-4-book.pdf
4486KB
|
|
|
|
