|
|
|
1 - 10 of
4,223 results for
Understanding debug atm event Output on ATM Router Interfaces
|
|
|
|
Multiple processors residing on a dedicated system processor module as well as locally on interface hardware work together to ensure successful transmission and receipt of packets over ATM virtual circuits (VCs). These processors communicate among themselves by posting messages...
www.cisco.com/en/US/products/hw/modules/ps2033/products_tech_note09186a00800d7780.shtml
15 Nov 2007
This document describes how ATM port adapters report traffic statistics and resolve issues with incorrect packet or byte counters displayed in the output of the show interface atm or show atm vc commands.
www.cisco.com/en/US/tech/tk39/tk48/technologies_tech_note09186a0080094ba1.shtml
18 Dec 2007
The Interim Local Management Interface (ILMI) is a protocol defined by the ATM Forum for setting and capturing physical layer,ATM layer,virtual path,and virtual circuit parameters on ATM interfaces. ILMI uses simple network management protocol (SNMP) messages...
www.cisco.com/en/US/tech/tk39/tk49/technologies_tech_note09186a008009484f.shtml
18 Dec 2007
A protocol generally is defined as the rules of communication between two devices. A signaling protocol defines the rules of communication between two ATM interfaces that are using signaling messages to create on-demand or switched virtual circuits (SVCs) to carry user data. ATM...
www.cisco.com/en/US/tech/tk39/tk49/technologies_tech_note09186a0080093d3c.shtml
15 Nov 2007
When you use Per-VC (distributed) Weighted Random Early Discard (Per-VC (D)WRED), you can perform an intelligent packet discard when congestion occurs. However, this solution limits you to the use of one Permanent Virtual Circuit (PVC) between two end devices. As a result, the different service classes...
www.cisco.com/en/US/tech/tk39/tk48/technologies_configuration_example09186a0080094e84.shtml
05 Jun 2005
...information about troubleshooting ATM port adapters and understanding the output from the debug commands, refer to Troubleshooting TechNotes on Cisco.com at the following...Statistics •Using the debug atm Commands •Displaying...statistics through the show interfaces atm command. Note For...from a Cisco 7200 series router: Router# show controllers...
www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/atm/pa-a3_ATM_install_config/5117cfg.html
14 Sep 2007
This document provides troubleshooting tips for ATM over digital signal level 3 (DS-3) and E3 router interfaces.
www.cisco.com/en/US/tech/tk39/tk48/technologies_tech_note09186a0080111093.shtml
15 Nov 2007
Before you can ping across an inverse multiplexing over ATM (IMA) interface, you need to ensure that both the IMA logical interface and the physical interfaces that make up that IMA logical interface are up and active. In some cases, these interfaces do not show...
www.cisco.com/en/US/tech/tk39/tk356/technologies_tech_note09186a0080093d52.shtml
05 Jun 2005
...Crashes on the PA-A3 Understanding debug atm event Output on ATM Router Interfaces Understanding the UBR+ Service Category...
www.cisco.com/en/US/products/hw/modules/ps2033/ps66/tsd_products_support_model_home.html
12 Sep 2012
...bytes, 0 underruns 0 output errors, 0 collisions, 5 interface resets 0 ouput buffer failures, 0 output buffers swapped out Tip For more information on understanding loopback modes on Cisco routers, refer to the ATM Technical Tips on Cisco...
www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/atm/pa-a2_atm_ces_install_config/3460conf.html
14 Sep 2007
|
|
|
|
