This signature fires when a configurable threshold for all UDP traffic is crossed. The level of all UDP traffic is monitored for any sudden increases to detect possible denial-of-service attack conditions.This signature is disabled by default. In order to properly utilize this signature, it must be put into "diagnostic" mode. This is done by enabling the signature, setting the "Rate" parameter to zero, and letting the sensor operate for a period of time. While in "diagnostic" mode, alarms will be generated with the current rate of all UDP traffic. Using these rates, a threshold should be chosen to indicate when the level of all UDP traffic is no longer within the acceptable range for the network being monitored. After the threshold is determined, it should be used as the value of "Rate" parameter for this signature.Note: This signature should not be left in "diagnostic" mode for permanent operation due to the performance overhead created by monitoring traffic rates.
LEGAL DISCLAIMER THE INFORMATION ON THIS PAGE IS PROVIDED ON AN "AS IS" BASIS AND DOES NOT IMPLY ANY KIND OF GUARANTEE OR WARRANTY, INCLUDING THE WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE. YOUR USE OF THE INFORMATION CONTAINED HEREIN, OR MATERIALS LINKED FROM THE DOCUMENT, IS AT YOUR OWN RISK. INFORMATION IN THIS DOCUMENT AND ANY RELATED COMMUNICATIONS IS BASED ON OUR KNOWLEDGE AT THE TIME OF PUBLICATION AND IS SUBJECT TO CHANGE WITHOUT NOTICE. CISCO RESERVES THE RIGHT TO CHANGE OR UPDATE THIS DOCUMENT AT ANY TIME.